If you have any questions or remarks, please contact us via the contact form on our website (https://noel-marquet.be/en/contact/). We will respond to your request as soon as possible.
Absolutely! To order samples, please click here https://noel-marquet.be/en/sample-order/ and to order the catalogue, please click here.
NOËL & MARQUET products are only sold through distributors, retailers and other professionals. Find a retailer near you in the “where to buy” section https://noel-marquet.be/en/where-to-buy/
The temperature resistance of NOËL & MARQUET profiles is +70°C.
All products of the WALLSTYL® (HDPS), ARSTYL® (PU) and DOMOSTYL® (PU) ranges are fully impact resistant.
The main weakness of MDF is its sensitivity to water. This is an issue when used in bathrooms, kitchens and when washing floors with water. A non-waterproof skirting board can deteriorate. WALLSTYL® skirtings are made of 100% polystyrene and are therefore naturally waterproof and dimensionally stable. WALLSTYL® skirtings are 100% waterproof and therefore offer a longer lifetime than MDF skirtings, which can become damaged and swell with water absorption.
To ensure successful installation, surfaces must be clean, dry, dust-free, degreased and smooth (roughen if necessary). Installation on damp substrates, under forced drying conditions or at very high temperatures should be avoided. Please refer to the installation instructions (https://noel-marquet.be/en/documents/).
We offer various adhesives that are suitable for mounting the products as well as for making the joints.
Apply the glue to the back of the profile and to the cut and make sure that there is a 3mm gap between the mitres when fitting. Remove the excess glue and flatten the joint with a spatula. Allow to dry (min. 6 hours), then lightly sand the joints with sanding paper (150 grain or finer). Then touch up the ceiling and wall joints and mitre joints with the adhesive.
Joints between ARSTYL® WALL PANEL and TILES do not need to be glued or plastered, but the wall and ceiling joints should be joined with ADEFIX® adhesive. For LIQUID and WAVE models, it is recommended to use tile spacers (1-2mm) to ensure an even distance between the panels. For other models, spacers are not necessary.
Use our calculator to find out what type of adhesive to use: https://noel-marquet.be/en/glue-consumption/
Absolutely! You can find our installation instructions on our website in the “documents” section and then “installation manual” or under the link https://noel-marquet.be/en/documents/
The temperature resistance of the profiles is +70°C, therefore it is important to ensure that the LED temperature does not exceed 70°C.
The more LEDs per metre, the less you will see the light spots. The diffuser provides an even, indirect and glare-free distribution of light.
The diffuser is made of ABS with an OPAL finish.